Two: puppy production process: after the balloon is blown, play 9 sections according to the picture description:
1, the lower segment of the balloon winds the second segment, and the number of turns varies from 1-3.
2. Balloon sections 5 and 6 are intertwined, and the number of turns varies from 1-3.
3. Section 8 is wound according to the schematic diagram, and the number of turns varies from 1-3 times.
4. Please pay attention to the schematic diagram of winding shape 4.
5. Insert the front foot of the puppy into the circle made in step 3.
To make a puppy with a balloon, you need to use a long balloon to make 80% balloon gas, and then you can mold all kinds of puppies by hand. The shapes of other animals, such as deer and giraffe, are all changed from the shapes of puppies. The specific operation steps are as follows:
Tools: five balloons and a pump.
1. Inflate the balloon to the end, leaving a tail of about 5 cm.
2. The first section is about 5 cm long and is used as the dog's nose; The second and third segments are smaller, about 2.5 cm long, and are used as dogs' ears.
3. Bend the remaining longest part side by side with the first short section, with the bending center between the second section and the third section.
4. Turn around and release your right hand. The balloon should be like a dog's head, and then it's finished.
Precautions:
Don't blow the balloon too big, it will explode easily. When inflating the balloon, avoid sharp things, otherwise, the balloon will burst easily.