1. Fold the red line in half and press it on the ring where the red line needs to be wound, so that one end of the red line is broken and the other end is connected.

2. Pick out a thread from the disconnected end, make a summary, and start winding the knotted thread around the connected end, circle by circle, and tighten it a little.

3. After winding the thread, thread your wound thread into one end of the connection, and then pull the remaining thread at the other end, and you will find that one end of the connection has shrunk.

4. Finally, pull the wound thread into the winding ring, tighten it, and cut off the remaining thread with scissors.

Other winding methods:

1, flat knot method. Flat knot method should first prepare a tough rope, bypass the ring, showing &; Ldquo, again. Font, follow the steps of winding the diagram, and then officially start after knotting (note that the knot is on the left or back side). Next, tie the second knot, the direction of the knot is opposite to the previous one, and continue to tie the knot until the extra thread is cut off. Note that the rope must be tightened during the whole process, otherwise it will come loose easily.

2. The second method is to adopt the circular encircling method, which can reduce the squeezing of fingers. First, prepare a winding. After bending, the other end is repeatedly wound on the ring. As shown in the winding diagram, after continuous winding, it goes out at the back bend, and the other side tightens the winding and cuts off the ends on both sides.