Origami bamboo stick

Second, the graphics course

First, prepare two pieces of square pleated paper, one large and one small. The big one is used as an umbrella, and the thin one is used as a support inside the umbrella. A rectangular piece of paper is needed as a handle.

The initial steps of large squares and fine squares are similar. Fold the square first, and then fold the front and back sides into triangles.

In fact, we need to have an "M" crease in the middle, then open the four sides of the square one by one, fold about 0.5cm in the middle of the triangle, and then restore the triangle crease to the original position of the square.

At this point, the square has been slightly arched outward, and the four consecutive sides have been folded up in the same way, which will become the prototype of the umbrella.

Then in the same way, fold the four corners of the square about 0.5cm in the middle position under one finger position of the corner position, then fold the corner position down and arch it again, which is the outer valley of the umbrella.

Please stick a small hole in the top of the umbrella with a toothpick for later use.

Next is the umbrella stand. We also fold it in half from the middle, then fold it in half from the middle and then fold it into a triangle.

In fact, we just want the pits with dotted lines. Then the hardest part is that we have to fold 1, 2, 3, 4, 1, 2 back to back into four groups, and 2 and 3 are opposite, that is, 1 and 4 pairs are folded.

Complete the four groups of "1, 2, 3, 4", and you will get the toys that you played "Southeast, Northwest" in that year. Of course, this is tightly buckled and cannot be moved.

First, use a toothpick to pierce a hole in it, and then use another piece of paper as the handle of the fan.

Then finish the part of the handle, and you can triple it.

Our beautiful little umbrella is ready. You can have a try.