2. The main method is the same as page 13, and the pen container steps are 1 1, 12, 13.

3. The method of adhesive tape is the same as steps 6, 7 and 8 on page 7 of the confetti tube, and 4 pieces are made.

4. Glue the four bodies tightly with white glue.

5. Glue the periphery with white glue.

6. Stick the wrapping paper on the outside line of the main body, cut it at the corner and stick it inside.

7. Cut off the left and right sides of the front face at the corner.

8. Stick the left and right sides inward.

9. Cut the upper and lower ends diagonally.

10, fold up and down and paste inward.

1 1. Cut a strip of wrapping paper and stick it on the diaphragm.

12, and then stick a vertical partition.

13. Stick the wrapping paper on the back.

14,4 drawer refers to the pen container drawer on page 13.

15, the wire is wrapped on the iron with wrapping paper as a pull ring.

16, bending.

17, put it in front of the drawer.

18, bending inward.

19, the pull ring is fixed with adhesive tape and complete.