Complete CISCO command
Enabling access allows the router to create temporary access list entries in the dynamic access list.
Access-group applies an access control list (ACL) to an interface.
The access list defines a standard IP
Bandwidth sets the bandwidth of the interface.
Bannermott specifies the date message slogan Bfe to set the emergency manual mode.
Boot System Specifies the system image that is loaded when the router is booted.
Calendar Settings Hardware Calendar
Cd replacement path
Cdp enable allows the interface to run CDP protocol.
Clear reset function
Clear Counter Clears the interface counter.
Clear the interface and restart the hardware logic on the interface.
Clockrate sets the clock rate of the serial port hardware connection, such as the rate acceptable to the network interface module and the interface processor.
Cmt turns on/off the FDDI connection management function.
Config-register modifies the configuration register settings.
Configure allows you to enter the existing configuration mode and maintain and save the configuration information on the central site.
Configuration memory loads configuration information from NVRAM.
Configure the terminal for manual configuration from the terminal.
Connect Open the terminal connection.
Copy copy configuration or image data.
Copy the flash tftp backup system image file to the TFTP server.
Debug uses the debugging function.
Debugging dialer shows what number the interface is dialing and so on.
Debugging ip rip shows rip routing update data.
Dial-up groups control access by configuring interfaces belonging to a specific dial-up group.
Enable turns on privileged mode.
Enable Passwords Determine passwords to prevent unauthorized access to the router.
Enable Passwords Set local passwords to control access at different permission levels.
Enabling encryption defines an additional layer of security for enabling password commands.
Encapsulate Frame Relay Start Frame Relay encapsulation.