Prepare materials and tools
Material: wood
3 boards of 2700* 120* 18.
At least 2 to 3 pieces of 2700* 1400* 18 cardboard (I personally recommend plywood).
Three extra-long screws with spirals? -? Paints and varnishes
Tools:? -? Vertical? -? driller
Diy bookcase making method
Step 1:
Fabrication of vertical plate and frame
First, cut out the shape of the board, vertical and horizontal lines.
The three vertical plates must be the same size. Shelves can be placed at will. Regardless of the size, the big one can hold two thick classical masterpieces and photo albums. These just need to change the length and width.
The trick is to cut a beautiful arc. The transverse plate is basically straight, but it is cut into an arc 40 cm from the end.
Step two:
Cutting and carving? The most complicated step in the whole process is to accurately saw out the notches that match the horizontal frame and the vertical frame. Each transverse plate is cut with three notches, as shown in the figure, one in the core and two at the ends of 20 cm. The notch on the riser is cut according to your own needs, because it directly determines the size of the grid space. Adjust the position of the incision according to the size of the book.
You can refer to my data: on the floor where the photo album is located, the distance between the two notches is 33 cm, 30 cm and 26 cm in turn. ? Accurate measurement, marking, and then cutting. If the measurement is not accurate enough, it means that the bookshelf is not balanced enough.
The width of all cuts should be 18 mm to facilitate the insertion of boards.
As for the depth of the incision, that is, the gap, that is the trick.
The riser is curved, so it is impossible to cut all the notches to the same depth. I suggest that the incisions are all smaller than the average width 1/2. For example, width 12 cm, incision 6 cm, width 6 cm and incision 3 cm.
It should be emphasized that all notches on the vertical plate should have the same size and depth.
The notch on the horizontal plate should match the notch on the vertical plate.
Step 3: Installation
Now you can assemble all the boards to see if they match well, then take them apart and paint and varnish them. Of course, if you know it, you can draw it directly.
Step 4: Embedding into the wall
After finishing all the painting work, assemble the boards where you want to put the bookcase. You don't need to install it except the board used as the top shelf.
Drill holes in the slot for placing the top frame, insert screws, pass through the board, and drill holes at corresponding points on the wall to fix them. If you are worried that there is not enough wood at the notch, you can drill holes in the board above the notch. ? The whole bookshelf is formed, and these holes are not visible, which is absolutely beautiful. So you can't see the screws from the outside, and it feels like the bookshelf exists independently.
Step 5: Finish? A bookshelf has been made successfully. Now you just need to put your book on it and enjoy the fun of small achievements.
Conclusion: The above is some information about DIY bookcases that Bian Xiao told you today. I believe you have a simple understanding of this information after reading Bian Xiao's story? In fact, the rules and design of making simple bookshelves at home are not so complicated, and the design is also very exquisite. As long as everyone likes it, they can do it according to their own ideas. Height, height and thinness are not a problem, as long as it loOKs good, it's ok!