Question 2: How to draw the reinforcement of Guanglianda slab is divided into two steps:
1, define the plate bearing bar first, and then draw the bearing bar.
2. Define the negative reinforcement of the board (remember that different negative reinforcement should be named with different lengths), and then draw it.
Question 3: How to draw steel bars in the slab for the calculation of steel bars in Guanglianda? You can input steel bars in a single member, and the manual calculation is also very fast.
Question 4: How to draw the long pole of Guanglianda steel plate? For new boards, you can choose "multi-board" layout or "custom range" layout, vertical or horizontal penalty, or xy layout, and you can arrange them.
Question 5: How to draw the cantilever steel bar on Guanglianda? I am a novice, and I want to provide two methods for the detailed process:
1, which is not accurate. The upper reinforcement and the lower reinforcement are arranged with stressed reinforcement. Suitable for emergency work, the error is not very big.
2. Relatively accurately, the lower reinforcement is arranged in the X and Y directions, and the upper reinforcement [email protected] is arranged in the negative reinforcement. The reinforcement is changed to [mail protection], and the unilateral marking position is "inside edge line of bearing". Break the calculation setting of 13, and change the 29th item "single mark the length of negative reinforcement anchored into the bearing" to HA-BHC+33.
Question 6: I can't tell the reinforcement of the slab clearly, and I don't know how to draw Guanglian Dali 1. The steel bars in the drawing are all cold-rolled ribbed steel bars with a diameter of 8mm, and the strength grade is shown in the general construction instructions.
2. The picture shows a single-layer two-way stiffener. The rebar at the bottom of the brown board is 8mm in diameter and the spacing is 180mm. Hook up, left;
3. The diameter of red bearing negative reinforcement (shoulder pole reinforcement) and negative reinforcement of plate edge structure is 8mm, the spacing is 100 and 150mm, and the dimension is the length from lyna to the turning point. Turn the hook down to the right;
4. h= 130 in the small box indicates that the thickness of this plate is 130mm.
Knowing this information, enter Guanglianda.
Question 7: How to draw the reinforcement of Guanglian Dali delivery board? Arrange the reinforcement of the plate, and then adjust the anchorage.
What exactly is the plate reinforcement in question CAD, and how does Guanglianda draw it? Consider drawing a single component at the bottom of the plate as additional reinforcement, and directly define the specification, degree and quantity; Want to draw a picture, define a picture with custom reinforcement.