2, full-time personnel training operation and maintenance.

3. Connect the grounding wire according to the position specified by the grounding mark.

4, the machine should be kept clean and tidy.

5. Before production, all parts of the machine must be oiled (refer to the operating regulations).

6. When the machine leaves the factory, the lubricating oil of the gearbox belt must be oiled before production.

7. It is suggested that this machine had better use an oil-free air compressor.

8, molding, heat sealing, indentation and other parts of the pressure should not be too large, otherwise it will affect the service life. There should be a floating space of about one millimeter for the pad for forming the indentation to rotate.