1, the transmission parts exposed outside the press must be equipped with a protective cover, and it is forbidden to start or test run with the protective cover removed.
2. Before driving, check whether the main fastening screws are loose, whether the mold is cracked, whether the longitudinal mechanism, automatic stop device, clutch and brake are normal, and whether the lubrication system is blocked or short of oil.
If necessary, you can drive an empty car for testing.
3. When installing the mold, the slider must be opened to the bottom dead center, and the closing height must be correct to avoid eccentric load as much as possible; The mould must be firmly fixed and checked by pressure test.
4, pay attention to at work, it is forbidden to put objects such as hands and tools into the danger zone.
Small pieces must be made with special tools (tweezers or feeding mechanism).
When the mold is stuck in the blank, only tools are allowed to release it.
5. If the printing machine has abnormal operation or abnormal sound (such as combo sound and cracking sound), stop feeding immediately and check the reason.
If the rotating parts are loose, the longitudinal device fails, the mold is loose and defective, the machine should be stopped for repair.
6. When cleaning each workpiece, hands or feet must leave the button or pedal to prevent misoperation.
7, more than two people, should be a person driving, pay attention to coordination.
Before coming off work, close the mold, turn off the power and clean it as necessary.