Step 1: Prepare.
Before installing the motor drive board of the treadmill, you need to prepare the tools and materials needed for installation. First of all, prepare the driving board of the treadmill motor, the connection between the motor and the control console, and the supporting screws, nuts, nut seats, wires and tool kits.
Step 2: Remove the old motor drive plate.
First of all, you need to remove the old motor drive board from the treadmill, and remember to unplug the treadmill when you remove it to avoid potential safety hazards.
Step 3: Install a new motor drive board.
Insert the new motor drive board into the socket on the console according to the original interface, connect the wiring between the motor and the console, and then fix the motor drive board on the console with matching screws. At this time, it should be noted that the screws should not be tightened too tightly to avoid damaging the motor drive board.
Step 4: Test Run
After the installation is completed, a trial run is needed to ensure the normal operation of the treadmill. First, you need to plug the power of the treadmill into the socket, and then turn on the power switch to adjust the speed and slope for testing. If there is no problem in the test operation, it means that the motor drive board has been successfully installed and can be used normally.
In a word, the installation of the motor drive board of the treadmill needs great care and patience to ensure the normal operation of the treadmill. At the same time, you need to pay attention to safety issues when operating, and don't change the circuit without authorization. If you don't have relevant experience or technology, you'd better ask a professional to install it.