1) After the forklift is started, the engine runs normally, and there is no oil leakage or water leakage. When the forklift lifts smoothly and the gantry tilts in place, you can start with gear. Operating essentials and requirements for starting on the flat ground. When the forklift starts on a flat road, the body should maintain the correct driving posture, and the eyes should be fixed on the road ahead, traffic conditions and goods, and don't look down.

① Quickly press the clutch pedal with your left foot, put the shift lever in I gear with your right hand, and put the reversing lever in forward gear or reverse gear. Generally, you should start from a low gear, such as I gear.

② Release the parking brake, turn on the turn signal and whistle.

③ While slowly lifting the clutch pedal, steadily press the accelerator pedal to make the forklift start slowly. At the same time, completely release the clutch pedal. Start-up requirements: it should be rapid and stable, without impulse, vibration and flameout, and the operation is accurate.

2) Operating essentials and requirements for starting on the ramp: ① Operating essentials A. When driving on the ramp of 10, stop in the slope, keep the engine running, put it in neutral, keep dynamic balance by the brake and accelerator pedal, and the car will not slide down. B. When starting, shift to the first forward gear, press the accelerator pedal, release the clutch pedal to semi-linkage at the same time, and hold the steering wheel tightly with one hand.

Release the parking brake with one hand. Then increase the throttle, release the clutch pedal and start uphill. C. At the beginning, if you feel backward or lack motivation, stop immediately and start again.