1, a mineral water bottle after drinking water, poke a hole in the bottleneck of the empty bottle with scissors (the bottle wall is soft, be careful not to hurt your hand), and put the scissors in.

2. Cut the water bottle along its upper end (keep the vertical part).

3. Then, cut the upper part of the opening of the water bottle with scissors (subject to the circular line at the bottom of the trademark paper).

4. Cut into strips step by step. Here's a trick. You don't need to draw a line. First cut a thread, then cut the opposite thread, then pass through the water bottle, and then cut the scissors halfway.

5, everything is divided into two parts, two parts are divided into four parts, four parts are divided into eight parts, eight parts are divided into sixteen parts, and finally such an upper strip is formed.

6. Fold the small strip outward from the uniform neckline position (it can be folded to 180, and then it will rebound elastically), so that the buckle forms a 90-degree angle with the bottle body.

7. Then, start to fold the decorative corner in one direction.

8. Pay attention to the parts with even corners and fold inward. The head of the tampon coincides with the bottle wall of the mineral water bottle and presses it into the other tampon.

9. Finally, a beautiful decorative edge is formed, and a small and exquisite mineral water environment-friendly vase is finished.

10, is it appropriate to put a pot of miniature orchids?