Second, the operation steps:
1. Refer to the pumpkin figure in figure 1, which is similar to a big flower pattern *** 16. Copy it on the orange cardboard in Figure 2, and then cut it slowly to get a "big orange flower".
2. Draw a little at the end of each petal with a pencil, draw a little evenly on all 16 petals, and then poke it gently with an awl. If you are skilled, you can poke the hole directly with an awl without drawing. Because the paper is still hard when sewing in the later stage, it will wrinkle when worn hard, so it should be punched first.
3. In order to make the pumpkin plump, we gently roll it with our fingers to bend it slightly inward.
4. String the pumpkins together. Thread a needle and tie a knot. Then start from any piece, the needle and thread pass through from bottom to top, and slowly connect one piece. Remember to pay attention to the order here. This is the principle of symmetry. Take the watch surface as an example. 12 points are connected with 6 points, then 3 points are connected with 9 points, and so on.
The worn pieces of paper are all connected at one end. At this time, it is good to tie the knot and fix it. Pumpkin is already very three-dimensional Small thread head We use green cardboard to make a split cylinder to cover it. Cut off the teeth of green cardboard at will, and then bend it with an awl. You don't have to stick your teeth when pasting, because the back will be folded and separated.
6, the small cylinder is the top of the pumpkin, just paste it. There are many different expressions on Halloween pumpkins. I chose a relatively simple triangle pattern combination. I will draw slowly, cut off the curved mouth, put the cut expression on it, and make a small pumpkin.