1. Draw the sheep of 10, then fold it in half from the middle according to the same number, and fold out the corresponding picture frame as needed. I used lead drawing paper for students at that time, and made 5 frames out of 6 frames.

Mark the spine of this book with a pen. The marks of several small books must be aligned, so that the final diy book will look neat. In this step, it is suggested to measure the length with a ruler and calculate the distance.

3. Make a small hole in the marked place with an awl. If there is no awl, you can use a needle, but it will be more laborious and easy to hurt your hand. There is a trick to this step. It's best to fix the paper with a paper clip, otherwise it will easily puncture.

4. Start binding books. From the second hole in the first frame, the first hole comes out.

5. Enter the first hole in the second frame and exit the second hole.

6. The needle is wound on the front thread. Just sew a few frames. Pay attention to sew each frame tighter. Sew the rest of the frame in this way.

7, prepare a ribbon or rope, as a bookmark, a piece of cloth almost as wide as the spine of the book, longer than the book. A piece of gauze is mainly used to fix the spine of the book.

8. Stick the other end of the bookmark on the spine of this book.

9. The two ends of the cloth strip are folded back and bonded, and the length is slightly longer than the spine of the book, and then fixed on the spine with hot melt adhesive. This can protect the spine of the book, so that the book will not spread when it is laid flat. If there is no hot melt adhesive, you can use white latex, but it dries slowly.

10, put on gauze. Then press it with a dictionary or something important for a while. It was made in the book. At that time, it was pressed under the glass plate of the desk ~ I finished it in this manual, and it is getting closer and closer to success!

12. Now let's make the cover. Cut paper cloth as shown in the figure, or you can use your favorite paper. I use corrugated paper on the carton, because this paper is thick and hard enough; The size is the same as the length of the notebook, the width is 0.5cm, and it is pasted on cloth or paper after cutting.

13, cut four seams at four corners, and then fold them in; Glue the four sides together as shown. The cover of the book is ready

14. Cut two pieces of paper as big as the book block and stick them on the book and cover.

15. After both sides are glued, the book is finished. Then click it with a dictionary.