operational approach
0 1
Prepare a pump and a long balloon, as shown in the figure below.
02
Blow up the long balloon with a pump. Remember not to blow it up completely. You need to reserve some space, as shown below.
03
Pinch a small bubble in front, which is the puppy's head, as shown below.
04
Pinch a bubble, the back is a little longer than the front, and then bend it. This is the puppy's ear, as shown in the picture below.
05
Pinch a longer bubble as the puppy's neck, as shown below.
06
Then pinch out the front foot like a puppy's ear, as shown below.
07
Pinch another bubble as its body, and then pinch its hind feet behind the body, as shown in the figure below.
08
Finally, draw eyes to see if they are cute or not!
1, first inflate the balloon until a small tail of about 5 cm remains. Why are you doing this? You can refer to the twisted balloon foundation in front.
2. Three consecutive "basic turns". The first paragraph is almost 5 cm long and will be used as a puppy's nose. The second and third paragraphs are relatively small, almost 2.5 cm long, and act as the ears of the puppy. Pay attention to these nodes by hand, so that the balloon will not spread out.
3. Bend the remaining longest part side by side with the first short segment, and the bending point is between the second short segment and the third short segment, so as to carry out the "interlocking" in our basic movements.
4. Release your right hand after twisting. A balloon should look like a dog's head.
5. Above the dog's head, follow three "basic twists" to form three ABC parts, each about 8 cm long. Section A should be the neck of the puppy, and section BC should form the front leg of the puppy. Remember to hold all these parts by hand, or they will fall apart.
6, now the balloon, you can see the first half of the puppy, head, neck, front legs.