Specific steps:

1, take a line of 140 cm and fold it in half. First, make a double connection, or make a new knot ... any knot can be used to fix the size of the buttonhole.

2. Take 130cm thread and fold it in half, and start weaving 4 strands.

3, look carefully, it is a ring buckle, the line should be tightened and evenly drawn. Practice repeatedly.

4, woven to 17 cm, almost a bracelet, the last strand ends after picking the head, and the remaining three strands are cut and ironed.

5. Leave a wisp, put on sandalwood beads, and you're done. Wear other beads as long as the hole is thick enough.

Note: When knitting the red rope bracelet, please note that if it is worn by men, the thread can be tightened, and if it is worn by women, the thread can be relaxed.

Required materials: foam board, pin, rope, beads, scissors.

Step by step method

1. Place the rope as shown in the figure, and then fix the rope with a pin.

2. Put the rope on the right on the middle rope on the left.

3. Put the left rope on the lower rope.

4. Pass the crossed rope through the hole on the right from bottom to top, and then tighten the ropes on both sides.

5. Repeat the previous step in the opposite direction. (? First put the left rope on the right central rope, and then put the right rope on the lower rope. Finally, put the rope above the cross through the hole on the left from bottom to top.

6. Tighten the ropes on both sides so that you can tie a flat knot.

7. Weave a flat knot at one end, then put on a bead, and finally hook the rope on the left and right sides into a flat knot with a crochet.

8. In order to make the bracelet elastic, we also need to fold the ropes at both ends together, and then add a rope in the middle to weave a new flat knot.

9. Thread the rope at both ends into the beads, and then tie a knot at the end of the rope. As shown above, a beautiful beaded bracelet is made. ?