First, start knitting from the belt. Start with 158 stitches. (Knit one stitch on each side) After flat knitting for about 2 inches, divide it into sections, and then knit down for about 1 inch, and divide it into sections. The vertical file is about 6 inches long. Then knit the trouser legs into loops.

Second, the method of closing the trouser legs is as follows: take 1 stitch on the front and back sides every six rows, and take 4 stitches at a time. When closed, the sixth needle next to the upper needle is combined with the second needle, and 1 needle still weaves the lower needle unchanged. By analogy with the required size, double rib can weave about 1.5 inch.

Third, pick the needle from the belt and weave the vest on it. Or pick out 158 stitches, 79 stitches in front and back, and weave separately. Knitting the front panel first: When knitting, after discounting 6 stitches at 20 stitches on both sides of 79 stitches, the remaining 66 stitches are arranged: 1, 1, 4 (4 rows 1 twist), 2, 4 (4 rows 1 twist) 2.

38 stitches, 2 up, 4 down (4 rows 1 twist) 2 up, 4 down (4 rows 1 twist), 1 up, 1 down. Close the seams on both sides like a trouser leg. After collecting the remaining 50 stitches on April 2-8, do not collect the stitches, and tidy the hem:

1, 1, 4 (twist) 2, 4 (twist) 2, 4 (twist), 2, 4 (twist), 2, 4 (twist), 2, 4 (twist), 2, 4 (twist). Retract the needle. Over.

Extended data:

1, prepare in advance-first decide the purpose and wearing object of knitting supplies.

2. Choose patterns or knitting patterns (such as gold and silver needles, upper and lower needles, ribbed needles or some patterns, etc.). ).

3. Buy suitable wool and knitting needles-the number of wool needed and the number of knitting needles needed are listed on the pattern, and you can buy them according to the instructions on the pattern. Of course, the amount of wool needed is slightly different according to the tightness of each person's knitting, but it is also a difference of one and a half points, so just follow the instructions on the pattern to buy it.

4. Make a knitting tightness standard-according to the label on the wool, use the required knitting needles to weave the standard number of stitches, weave the low stitches on the front, weave the high stitches on the back, and then close the stitches. If this small square is 10 cm x 10 cm, you can start knitting according to the pattern.

If the finished product is greater than 10 cm x 10 cm, it is loose; If it is less than 10 cm x 10 cm, it is tight. Solution: too loose-use with caution; To the knitting needle; It is too tight with a large needle.